Performance, Emission and Combustion Characteristics of a Variable Compression Ratio Diesel Engine Fueled with Karanj Biodiesel and Its Blends

Authors: Ajay V. Kolhe, R. E. Shelke, S. S. Khandare

Abstract:

The use of biodiesel in conventional diesel engines results in substantial reduction of unburned hydrocarbon, carbon monoxide and particulate matters. The performance, emission and combustion characteristics of a single cylinder four stroke variable compression ratio engine when fueled with Karanja (Pongamia) methyl ester and its 10-50 % blends with diesel (on a volume basis) are investigated and compared with standard diesel. The suitability of karanja methyl ester as a biofuel has been established in this study. The useful brake power obtained is similar to diesel fuel for all loads. Experiment has been conducted at a fixed engine speed of 1500 rpm, variable load and at compression ratios of 17.5:1 and 18.5:1. The impact of compression ratio on fuel consumption, combustion pressures and exhaust gas emissions has been investigated and presented. Optimum compression ratio which gives best performance has been identified. The results indicate longer ignition delay, maximum rate of pressure rise, lower heat release rate and higher mass fraction burnt at higher compression ratio for pongamia oil methyl ester when compared to that of diesel. The brake thermal efficiency for pongamia oil methyl ester blends and diesel has been calculated and the blend B20 is found to give maximum thermal efficiency. The blends when used as fuel results in reduction of carbon monoxide, hydrocarbon and increase in nitrogen oxides emissions. PME as an oxygenated fuel generated more complete combustion, which means increased torque and power. This is also supported with higher thermal efficiencies of the PME blends. NO_x is slightly increased due to the higher combustion temperature and the presence of fuel oxygen with the blend at full load. PME as a new Biodiesel and its blends can be used in diesel engines without any engine modification.

Keywords: Variable compression ratio CI engine, performance, combustion, emissions, biodiesel.

Digital Object Identifier (DOI): doi.org/10.5281/zenodo.1094201

References:

[1] Avinash kumar Agarwal., " Biofuels (alcohol and biodiesel) applications as fuels for internal combustion engines,” Progress in energy and combustion science 33 (2007) 233-271.
[2] Md. N. Nabi, Md. S. Akhter, M. Shahadat, "Improvement of engine emissions with conventional diesel fuel and diesel-biodiesel blends”., Bioresource Technology 97(2006),372-378.
[3] M.M. Azam, A. Waris, N.M. Nahar, " Prospects and potential of fatty acid methyl esters of some non-traditional seed oils for use as biodiesel in India, Biomass & Biotechnology 29(2005), 293-302.
[4] A.S. Ramadhas, C. Muraleedharan, S. Jayaraj, "Performance and emission evaluation of a diesel engine fueled with methyl esters of rubber seed oil”, Renewable Energy 30(2005), 1789-1800.
[5] S.K. Karmee, A. Chadha, "Preparation of biodiesel from crude oil of Pongamia Pinnata”, Bioresource Technology 96(2005), 1425-1429.
[6] K. Anand, R.P.Sharma, P.S.Mehta, "Experimental investigations on combustion, performance and emission characteristics of neat karanji biodiesel and its methanol blend in a diesel engine” , Biomass and bioenergy 35 (2011) 533-541.
[7] P.V.Rao, "Experimental investigations on the influence of properties of Jatropha biodiesel on performance, combustion and emission characteristics of a DI-CI engine” , World academy of science, engineering and technology 75 (2011) 855-867.
[8] A.S. Ramadhas, C. Muraleedharan., "Performance and emission evaluation of a diesel engine fueled with methyl esters of rubber seed oil”., RenewableEnergy30(2005),1789-1800.
[9] Mustafa C., Eradil A., Arcaklioglu E., " Performance and Exhaust emissions of a Biodiesel engine”, Applied Energy 83(2006),594-605.
[10] Deepak Agrawal, S. Sinha, A. Agrawal, " Experimental investigation of control of NOx emissions in Biodiesel-fueled Compression ignition engine.”, 6 December 2005, Renewable Energy.
[11] Mustafa Balat, "Potential alternatives to edible oils for biodiesel production- a review of current work” , Energy conversion and management 52 (2011) 1479-1492.
[12] G.R.Kannan, R.Anand, "Effect of injection pressure and injection timing on Di diesel engine fuelled with biodiesel from waste cooking oil” , Biomass and bioenergy 46 (2012) 343-352.
[13] M.G.Bannikov, "Combustion and emission characteristics of Mustard biodiesel” , 6th International advanced Technologies symposium (IATS’11), 16-18 May 2011, Elazig Turkey, 132-136.
[14] Breda Kegl, "Influence on engine combustion and emission characteristics” , Applied energy 88 (2011) 1803-1812.
[15] K.Muralidharan, D.Vasudevan, "Performance, emission and combustion characteristics of a variable compression ratio engine using methyl esters of waste cooking oil and diesel blend” , Applied energy 88 (2011) 3959-3968.
[16] Senthil Kumar M, Ramesh A, Nagalingam B. An experimental comparison of methods to use methanol and Jatropha oil in compression ignition engine. Biomass Bio Energy 2003;25:309–18.
[17] Rakopoulos CD, Antonopoulos KA, Rakopoulos DC, Hountalas DT, Giakoumis EG. Comparative performance and emissions study of a direct injection diesel engine using blends of diesel fuel with vegetable oils or bio – diesels of various origins. Energy Convers Manage 2006;47:3272–87.
[18] Saravanan S, Nagarajan G, Lakshmi Narayana Rao G, Sampath S. Combustion Characteristics of a stationary diesel engine fuelled with a blend of crude rice bran oil methyl ester and diesel. Energy 2010; 35:94–100.
[19] Heywood JB. Internal combustion engine fundamentals. McGraw Hill Book Co;1988.