A CFD Study of Turbulent Convective Heat Transfer Enhancement in Circular Pipeflow

Authors: Perumal Kumar, Rajamohan Ganesan

Abstract:

Addition of milli or micro sized particles to the heat transfer fluid is one of the many techniques employed for improving heat transfer rate. Though this looks simple, this method has practical problems such as high pressure loss, clogging and erosion of the material of construction. These problems can be overcome by using nanofluids, which is a dispersion of nanosized particles in a base fluid. Nanoparticles increase the thermal conductivity of the base fluid manifold which in turn increases the heat transfer rate. Nanoparticles also increase the viscosity of the basefluid resulting in higher pressure drop for the nanofluid compared to the base fluid. So it is imperative that the Reynolds number (Re) and the volume fraction have to be optimum for better thermal hydraulic effectiveness. In this work, the heat transfer enhancement using aluminium oxide nanofluid using low and high volume fraction nanofluids in turbulent pipe flow with constant wall temperature has been studied by computational fluid dynamic modeling of the nanofluid flow adopting the single phase approach. Nanofluid, up till a volume fraction of 1% is found to be an effective heat transfer enhancement technique. The Nusselt number (Nu) and friction factor predictions for the low volume fractions (i.e. 0.02%, 0.1 and 0.5%) agree very well with the experimental values of Sundar and Sharma (2010). While, predictions for the high volume fraction nanofluids (i.e. 1%, 4% and 6%) are found to have reasonable agreement with both experimental and numerical results available in the literature. So the computationally inexpensive single phase approach can be used for heat transfer and pressure drop prediction of new nanofluids.

Keywords: Heat transfer intensification, nanofluid, CFD, friction factor

Digital Object Identifier (DOI): doi.org/10.5281/zenodo.1333752

References:

[1] D.Wen, Y.Ding, Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditions, International Journal of Heat and Mass Transfer 47 (2004) 5181- 5188.
[2] S.Zeinali Heris, S.G.Etemad, M.Nasr Esfahany, Experimental investigation of oxide nanofluids laminar flow convective heat transfer, International Communications in Heat and Mass Transfer 33 (2006) 529-535.
[3] K.S.Hwang, S.K.Jang, S.U.S.Chio, Flow and convective heat transfer characteristics of water-based Al2O3 nanofluids in fully developed laminar flow regime, International Journal of Heat and Mass Transfer, 52 (2009) 193-199.
[4] D.Kim, Y.Kwon, Y.Cho, C.Li, S.Cheong, Y.Hwang, J.Lee, D.Hong, and S.Moon, Convective heat transfer characteristics of nanofluids under laminar and turbulent flow conditions, Current Applied Physics, 9 (2009) 119-123.
[5] U.Rea, T.McKrell, L.W.Hu, J.Buongiorno, Laminar convective heat transfer and viscous pressure loss of alumina-water and zirconia-water nanofluids, International Journal of Heat and Mass Transfer, 52 (2009) 2042-2048.
[6] R.Ben Mansour, N.Galanis, C.T.Nguyen, Experimental study of mixed convection with water Al2O3 nanofluid in inclined tube with uniform wall heat flux, International Journal of Thermal Sciences, 50 (2011) 403-410.
[7] T.H.Nassan, S.Zeinali Heris, S.H.Noie, A comparison of experimental heat transfer characteristics for Al2O3/water and CuO/water nanofluids in square cross-section duct, International Communications in Heat and Mass Transfer, 37 (2010) 924 - 928.
[8] L.S. Sundar and K.V.Sharma, Turbulent heat transfer and friction factor of Al2O3 Nanofluid in circular tube with twisted tape inserts, International Journal of Heat and Mass Transfer 53 (2010) 1409 - 1416.
[9] B.Farajollahi, S.Gh.Etemad, M.Hojjat, Heat transfer of nanofluids in a shell and tube heat exchanger, International Journal of Heat and Mass Transfer, 53 (2010) 12 - 17.
[10] Y.Xuan, Q.Li, Investigation on convective heat transfer and flow features of nanofluids, Journal of Heat Transfer, 125 (2003) 151-155.
[11] R.S.Vajjha, D.K.Das, D.P.Kulkarni, Development of new correlations for convective heat transfer and friction factor in turbulent regime for nanofluids, International Journal of Heat and Mass Transfer, 53 (2010) 4607 - 4618.
[12] M.Nasiri, S.Gh.Etemad, R.Bagheri, Experimental heat transfer of nanofluid through an annular duct, International Communications in Heat and Mass Transfer, 38 (2011) 958-963.
[13] S.Sonawane, K.Patankar, A.Fogla, B.Puranik, U.Bhandarkar, S.Sunil Kumar, An experimental investigation of thermo-physical properties and heat transfer performance of Al2O3-Aviation Turbine Fuel nanofluids, Applied Thermal Engineering, 31 (2011) 2841 - 2849.
[14] S.E.B.Maiga, S.J.Palm, C.T.Nguyen, G.Roy, N.Galanis, Heat transfer enhancement by using nanofluids in forced convection flows, International Journal of Heat and Fluid flow, 26 (2005) 530 - 546.
[15] M.Akbari, A.Behzadmehr, F.Shahraki, Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid, International Journal of Heat and Fluid flow, 29 (2008) 545 - 556.
[16] V. Bianco, F. Chiacchio, O. Manca, S. Nardini, Numerical investigation of nanofluids forced convection in circular tubes, Applied Thermal Engineering, 29 (2009) 3632 - 3642.
[17] R. Lotfi, Y. Saboohi, A.M. Rashidi, Numerical study of forced convective heat transfer of Nanofluids: Comparison of different approaches, International Communications in Heat and Mass Transfer, 37 (2010) 74 - 78.
[18] V. Bianco, O. Manca, S. Nardini, Numerical investigation on nanofluids turbulent convection heat transfer inside a circular tube, International Journal of Thermal Sciences, 50 (2011) 341-349.
[19] M. Akbari, N. Galanis, A. Behzadmehr, Comparative analysis of single and two-phase models for CFD studies of nanofluid heat transfer, International Journal of Thermal Sciences, 50 (2011) 1343 - 1354.
[20] B.C. Pak, Y.-I. Cho, Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles, Experimental Heat Transfer, 11 (1998) 151-155.
[21] V. Gnielinski, New equations for heat and mass transfer in turbulent pipe and channel flow, International Chemical Engineering, 16 (1976) 359-368.
[22] F.M. White, Viscous Fluid Flow, McGraw Hill, New York, 1991.
[23] J. Buongiorno, Convective transport in nanofluids, Journal of Heat Transfer, 128 (2006) 240-250.
[24] J.-H. Lee, K.S. Hwang, S.P. Jang, B.H. Lee, J.H. Kim, S.U.S. Choi, C.J. Choi, Effective viscosity and thermal conductivities of aqueous nanofluids containing low volume concentrations of Al2O3 nanoparticles, International Journal of Heat and Mass Transfer, 51 (2008) 2651-2656.