Numerical Analysis of Thermal Conductivity of Non-Charring Material Ablation Carbon-Carbon and Graphite with Considering Chemical Reaction Effects, Mass Transfer and Surface Heat Transfer

Authors: H. Mohammadiun, A. Kianifar, A. Kargar

Abstract:

Nowadays, there is little information, concerning the heat shield systems, and this information is not completely reliable to use in so many cases. for example, the precise calculation cannot be done for various materials. In addition, the real scale test has two disadvantages: high cost and low flexibility, and for each case we must perform a new test. Hence, using numerical modeling program that calculates the surface recession rate and interior temperature distribution is necessary. Also, numerical solution of governing equation for non-charring material ablation is presented in order to anticipate the recession rate and the heat response of non-charring heat shields. the governing equation is nonlinear and the Newton- Rafson method along with TDMA algorithm is used to solve this nonlinear equation system. Using Newton- Rafson method for solving the governing equation is one of the advantages of the solving method because this method is simple and it can be easily generalized to more difficult problems. The obtained results compared with reliable sources in order to examine the accuracy of compiling code.

Keywords: Ablation rate, surface recession, interior temperaturedistribution, non charring material ablation, Newton Rafson method.

Digital Object Identifier (DOI): doi.org/10.5281/zenodo.1331227

References:

[1] S.R. Candane, C.Balaji, and S.P.Venkateshan, A Comparison of Quasi one-Dimensional and two-dimensional Ablation Models for Subliming Ablators, International Journal of Heat transfer engineering, 30(3):229- 236, 2009.
[2] A. Mazzaracchio, M. Marchetti, A probabilistic sizing tool and Monte Carlo analysis for entry vehicle ablative thermal protection systems, Acta Astronautica,2009.
[3] J. D. Anderson, Hypersonic and high temperature gas dynamics. McGraw-Hill,1989.
[4] A.J Amar Modeling of One-dimensional Ablation With Porous Flow Using Finite Control Volume Procedure, requirements for the Degree of Master of Science. Raleigh 2006.
[5] J. Lachaud, Y. Aspa, G.L. Vignoles, International Journal of Heat and Mass Transfer 51(9-10) 2618-2627, 2008.
[6] E.Fitzer, L.M Manocha, Carbon Reinforcements and C/C composites, Springer, p. 342. 1998.
[7] G.duffa, G.L.vignoles, J.M. Goyheneche, Y.Aspa, International Journal of Heat and Mass transfer 48(16):3387-3401, 2005.
[8] H. Hurwics., Aerothermochemistry studies in Ablation ., Thermo dynamics Analysis section, Research and Advanced Development Division. Avco Corporation, Wilmington, Massachusetts, 1963.
[9] G. W. Russell, Analytic Modeling and Experimental validation of In tumescent Behavior of Charring Heat shield MaterialsÏî Technical Report AMR-PS-04-05, January 2004.
[10] R. L. Potts., Application of Integral Methods to Ablation Charring Erosion, AIAA/ASME Thermo physics and Heat Transfer Conference, June 1990.
[11] V. S. Arpaci, Conduction Heat Transfer, Addison-Wesely, Reading, MA, 1966.
[12] R. M. Kendall, E. P. Bartlett, R. A. Rindal and C. B. Moyer, An Analysis of The Coupled Chemically Reacting Boundary Layer and Charring Ablator, Part 1, June,NASA CR-1060,1968.