A 5-V to 30-V Current-Mode Boost Converter with Integrated Current Sensor and Power-on Protection

Authors: Jun Yu, Yat-Hei Lam, Boris Grinberg, Kevin Chai Tshun Chuan

Abstract:

This paper presents a 5-V to 30-V current-mode boost converter for powering the drive circuit of a micro-electro-mechanical sensor. The design of a transconductance amplifier and an integrated current sensing circuit are presented. In addition, essential building blocks for power-on protection such as a soft-start and clamp block and supply and clock ready block are discussed in details. The chip is fabricated in a 0.18-μm CMOS process. Measurement results show that the soft-start and clamp block can effectively limit the inrush current during startup and protect the boost converter from startup failure.

Keywords: Boost Converter, Current Sensing, Power-on protection, Step-up Converter, Soft-start.

Digital Object Identifier (DOI): doi.org/10.5281/zenodo.1339169

References:

[1] Kamyar Keikhosravy, et. al., “On the design of digitally assisted voltage regulators”, 2015 ICCE, pp. 445-446, 2015.
[2] Kazuaki Mori et al., “Analog-Assisted Digital Low Dropout Regulator (AAD-LDO) with 59% Faster Transient Response and 28% Ripple Reduction”, Int. Conf. on Solid State Dev. and Materials, Fukuoka, pp. 888-889, 2013.
[3] “Understanding Boost Power Stages in Switch mode Power Supplies”, Application Report, Texas Instruments, 1999.
[4] “Basic Calculation of a Boost Converter’s Power Stage”, Application Report, Texas Instruments, 2010.
[5] Martin, “Boost Converter Design Tips”, National Semiconductor, 2005.
[6] Y. H. Lam, W. H. Ki and D. S. Ma, “Loop Gain Analysis and Development of High-speed High-accuracy Current Sensors for Switching Converters”, in Proc. ISCAS, 2004.