Broadband Baseband Impedance Control for Linearity Enhancement in Microwave Devices

Authors: Muhammad Akmal Chaudhary

Abstract:

The out-of-band impedance environment is considered to be of paramount importance in engineering the in-band impedance environment. Presenting the frequency independent and constant outof- band impedances across the wide modulation bandwidth is extremely important for reliable device characterization for future wireless systems. This paper presents an out-of-band impedance optimization scheme based on simultaneous engineering of significant baseband components IF1 (twice the modulation frequency) and IF2 (four times the modulation frequency) and higher baseband components such as IF3 (six times the modulation frequency) and IF4 (eight times the modulation frequency) to engineer the in-band impedance environment. The investigations were carried out on a 10W GaN HEMT device driven to deliver a peak envelope power of approximately 40.5dBm under modulated excitation. The presentation of frequency independent baseband impedances to all the significant baseband components whilst maintaining the optimum termination for fundamental tones as well as reactive termination for 2nd harmonic under class-J mode of operation has outlined separate optimum impedances for best intermodulation (IM) linearity.

Keywords: Active load-pull, baseband, device characterisation, waveform measurements.

Digital Object Identifier (DOI): doi.org/10.5281/zenodo.1110852

References:

[1] Joel Vuolevi and Timo Rahkonen, Distortion in RF Power Amplifiers, Norwood, MA: Artech House, 2003.
[2] B. Kenington, High-Linearity RF Amplifier Design, Norwood, MA: Artech House, 2000.
[3] C. Fan and K. M. Cheng, “Theoretical and experimental study of amplifier linearization based on harmonic and baseband signal injection technique,” IEEE Trans. Microwave Theory Tech., vol. 50, pp. 1801– 1806, July 2002.
[4] J. Vuolevi, J. Manninen, T. Rahkonen, “Cancelling the memory effects in RF power amplifiers”, IEEE International Circuits and Systems Symposium, 2001, pp. 57–60.
[5] S. C. Cripps, Advanced Techniques in RF Power Amplifier Design, Norwood, MA, Artech House, 2006.
[6] M. D. LeFevre, D. W. Runton, C. T. Burns, M. K. Mellor, “Digital Predistortion from an RF Perspective”, 2010 IEEE Topical Symposium on Power Amplifiers for Wireless Communications, September 2010.
[7] Z. Yusoff, J. Lees, P. J. Tasker, J. Benedikt, S.C. Cripps, “Linearity Improvement in RF Power Amplifier System Using Integrated Auxiliary Envelope Tracking System”, in Proc. of IEEE MTT-S International, June 2011, pages: 1 -4.
[8] A. Alghanim, J. Benedikt, P.J. Tasker, P “A measurement test-set for characterisation of high power LDMOS transistors including memory effects” Proceedings of High Frequency Postgraduate Student Colloquium, 5-6 September 2005 Page(s): 29 – 32.
[9] A. Alghanim, J. Lees,T. Williams, J. Benedikt, P.J. Tasker, “Using active IF load-pull to investigate electrical base-band induced memory effects in high-power LDMOS transistors,” in Proc. Asia-Pacific Microwave Conference, 2007, 11-14 Dec. 2007 Page(s):1 - 4.
[10] J. Lees, T. Williams, S. Woodington, P. McGovern, S. Cripps, J. Benedikt, and J. Tasker, “Demystifying Device related Memory Effects using Waveform Engineering and Envelope Domain Analysis,” European Microwave Conf., Oct. 2008, Amsterdam, pp:753-756.
[11] A. Alghanim, J. Lees,T. Williams, J. Benedikt, P.J. Tasker, P “Using active IF load-pull to investigate electrical base-band induced memory effects in high-power LDMOS transistors,” Proceedings of Asia-Pacific Microwave Conference, December 2007, Page(s):1 - 4.
[12] M. Akmal, J. Lees, S. Bensmida, S. Woodington, J. Benedikt, K. Morris, M. Beach, J. McGeehan, P. J. Tasker, “ The Impact of Baseband Electrical Memory Effects on the Dynamic Transfer Characteristics of Microwave Power Transistors”, in Proc. of 4th International Nonlinear Microwave Monolithic Integrated Circuit(INMMIC), April 2010, pages: 148 – 151.
[13] T. Williams, J. Benedikt, P. J. Tasker, “Fully Functional Real Time Non-Linear Device Characterization System Incorporating Active Load Control”, in Proc. 36th European Microwave Conference (EuMC), October 2006, pages: 1610-1613.
[14] T. Williams, J. Benedikt, P. J. Tasker, “Experimental evaluation of an active envelope load pull architecture for high speed device characterization”, in Proc. IEEE MTT-S Int. Microwave Symp. Dig., Long Beach, June 2005, pages: 1509-1512.
[15] M. Akmal, J. Lees, S. Bensmida, S. Woodington, V. Carrubba, S. Cripps, J. Benedikt, K. Morris, M. Beach, J. McGeehan, P. J. Tasker, “The Effect of Baseband Impedance Termination on the Linearity of GaN HEMTs”, 40th IEEE European Microwave Conference(EuMC), September 2010, pages: 1046 -1049.
[16] M. Akmal, J. Lees, V. Carrubba, S. Bensmida, S. Woodington, J. Benedikt, K. Morris, M. Beach, J. McGeehan, P. J. Tasker, “Minimization of Baseband Electrical Memory Effects in GaN HEMTs Using IF Active Load-pull”, in Proc. Of IEEE Asia Pacific Microwave Conference (APMC. December 2010), pages: 5-8.
[17] M. Akmal, V. Carrubba, J. Lees, S. Bensmida, S. Woodington, J. Benedikt, K. Morris, M. Beach, J. McGeehan, P. J. Tasker, “Linearity Enhancement of GaN HEMTs under Complex Modulated Excitation by Optimizing the Baseband Impedance Environment”, in Proc. of IEEE MTT-S International. Microwave Symposium, June 2011, pages(s):1-4.
[18] M. Akmal, J. Lees, , J. Benedikt, P.J. Tasker, Characterization of electrical memory effects for complex multi-tone excitations using broadband active baseband load-pull”, in Proc. of 42nd European Microwave Conference (EuMC), October 2012, pages: 1265 -1268.
[19] Chaudhary, M.A.; Lees, J.; Benedikt, J.; Tasker, P., “Reduction of baseband electrical memory effects using broadband active baseband load-pull”, in Proc. of IEEE Internation Wireless Symposium (IWS), April 2013, pages: 1 - 4.
[20] P. Wright, J. Lees, P. J. Tasker, J. Benedikt, S.C. Cripps, “An efficient, linear, broadband class-J-mode PA realised using RF waveform engineering”, in Proc. of IEEE MTT-S International, June 2009, pages: 653 -656.
[21] V. Carrubba, A. L. Clarke, M. Akmal, J. Lees, J. Benedikt, P. J. Tasker, S. C. Cripps, “On the Extension of the Continuous Class-F Mode Power Amplifier,” IEEE Trans. Microw, Theory and Tech., vol. 59, March 2011, pp. 1294-1303.
[22] V. Carrubba, J. Lees, J. Benedikt, P. J. Tasker, S. C. Cripps, ”A Novel Highly Efficient Broadband Continuous Class-F RFPA Delivering 74% Average Efficiency for an Octave Bandwidth,” Proceeding of the IEEE MTT-S Dig., June 2011, pages: 1 – 4.