Ignition Delay Correlation for a Direct Injection Diesel Engine Fuelled with Automotive Diesel and Water Diesel Emulsion
Commenced in January 2007
Frequency: Monthly
Edition: International
Paper Count: 32799
Ignition Delay Correlation for a Direct Injection Diesel Engine Fuelled with Automotive Diesel and Water Diesel Emulsion

Authors: K.Alkhulaifi, M. Hamdalla

Abstract:

Most of ignition delay correlations studies have been developed in a constant volume bombs which cannot capture the dynamic variation in pressure and temperature during the ignition delay as in real engines. Watson, Assanis et. al. and Hardenberg and Hase correlations have been developed based on experimental data of diesel engines. However, they showed limited predictive ability of ignition delay when compared to experimental results. The objective of the study was to investigate the dependency of ignition delay time on engine brake power. An experimental investigation of the effect of automotive diesel and water diesel emulsion fuels on ignition delay under steady state conditions of a direct injection diesel engine was conducted. A four cylinder, direct injection naturally aspirated diesel engine was used in this experiment over a wide range of engine speeds and two engine loads. The ignition delay experimental data were compared with predictions of Assanis et. al. and Watson ignition delay correlations. The results of the experimental investigation were then used to develop a new ignition delay correlation. The newly developed ignition delay correlation has shown a better agreement with the experimental data than Assanis et. al. and Watson when using automotive diesel and water diesel emulsion fuels especially at low to medium engine speeds at both loads. In addition, the second derivative of cylinder pressure which is the most widely used method in determining the start of combustion was investigated.

Keywords: gnition delay correlation, water diesel emulsion, direct injection diesel engine

Digital Object Identifier (DOI): doi.org/10.5281/zenodo.1075525

Procedia APA BibTeX Chicago EndNote Harvard JSON MLA RIS XML ISO 690 PDF Downloads 5749

References:


[1] Brown, K.F., D.D. Chadderton, and D.D. Lnger, Opportunity for diesel emission reductions using advanced catalysts and water blend fuels. SAE 2000-01-0182, 2000.
[2] Daly, D.T. Future fuels and fuel additives for vehicle emissions control. 2000. San Francisco, CA: American Chemical Society National Meeting.
[3] Daly, D.T. and D.A. Langer. Low emission water blend diesel fuel. 1999. Toronto, Canada: Canadian Mining Diesel Conference Proceedings.
[4] Subramanian, K.A. and A. Ramesh, Use of Hydrogen Peroxide to Improve the Performance and Reduce Emissions of a CI Engine Fuelled with Water Diesel Emulsions. 2008.
[5] Greeves, G., I.M. Onion, and G. Khan. Effects of water introduction on diesel engine combustion and emissions. in 16th symposium international on combustion. 1976: The Combustion Institute.
[6] Radwan, M.S. and H. Salem, A study of some combustion characteristics of gas oil/water emulsions in a swirl chamber diesel engine. SAE 892056, 1989.
[7] Heywood, J.B., Internal combustion engine fundamentals. 1988.
[8] Lee, J.H. and N. Lida, Combustion of diesel spray injected into reacting atmosphere of propane-air homogeneous mixture. Int. J. Engine Res., 2001. 2(1): p. 69-80.
[9] Aligrot, C., J.C. Champoussin, N. Guerrassi, et al., A correlative model to predict autoignition delay of diesel fuels. SAE transactions, 1997. 106(3): p. 958-963.
[10] Wolfer, H.H., Ignition lag in diesel engines. VDI-Forschungsheft, 1938. 392: p. 621-436.047.
[11] Hiroyasu, H., T. Kadota, and M. Arai, Development and Use of a Spray Combustion Modeling to Predict Diesel Engine Efficiency and Pollutant Emissions: Part 2 Computational Procedure and Parametric Study. Bulletin of JSME, 1983. 26(214): p. 576-583.
[12] Kadota, T., H. Hiroyasu, and H. Oya, Spontaneous ignition delay of a fuel droplet in high pressure and high temperature gaseous environments. JSME, Bulletin, 1976. 19: p. 437-445.
[13] Stringer, E.W., A.E. Clarke, and J.S. Clarke, The spontaneous ignition of hydrocarbon fuels in a flowing system. Proc. Inst. Mech. Eng, 1970. 184: p. 212-224.
[14] Watson, N., A.D. Pilley, and M. Marzouk, A Combustion Correlation for Diesel Engine Simulation. SAE 800029, 1980.
[15] Assanis, D.N., Z.S. Filipi, S.B. Fiveland, et al., A predictive ignition delay correlation under steady-state and transient operation of a direct injection diesel engine. J. Eng. Gas Turbines Power 2003. 125: p. 450.
[16] Hardenberg, H.O. and F.W. Hase, Empirical Formula for Computing the Pressure Rise Delay of a Fuel From its Cetane Number and From the Relevant Parameters of Direct-Injection Diesel Engines. SAE 790493, 1979: p. 88.
[17] Lyn, W.T. Study of burning rate and nature of combustion in diesel engines. in Ninth international symposium on combustion. 1963: The combustion institute.
[18] Spadaccini, L.J., Autoignition Characteristics of Hydrocarbon Fuels at Elevated Temperatures and Pressures. J Eng Power Trans ASME, 1977. 99: p. 83-87.
[19] Spadaccini, L.J. and J.A. TeVelde, Auto-ignition Characteristics of Aircraft-Type Fuel. Combustion and Flame, 1982. 46: p. 283-300.
[20] Stern, F., M. Muste, M.L. Beninati, et al., Summary of Experimental Uncertainty Assessment Methodology with Example. IIHR Report, 1999. 406.
[21] Henein, N.A. and J.A. Bolt, Correlation of air charge temperature and ignition delay for several fuels in a diesel engine. SAE 690252, 1969.
[22] Syrimis, M., K. Shigahara, and D.N. Assanis, Correlation between knock intensity and heat transfer under light and heavy knock conditions in a spark ignition engine. SAE 960495, 1996.
[23] Gong, J.-S. and W.-B. Fu, A study on the effect of more volatile fuel on evaporation and ignition for emulsified oil. Fuel, 2001. 80: p. 437-445.
[24] Kumar, I.N.N., S.C. Prasad, and B.V.A. Rao, Heat release rate analysis of a DI diesel engine using diesel and seawater semi-stable emulsion. SAE 2002-01-2719, 2002.
[25] Nazha, M.A.A., H. Rajakaruna, and S.A. Wagstaff, The use of emulsion, water induction and EGR for controlling diesel engine emissions. SAE 2001-01-1941, 2001.
[26] Park, J.W., K.Y. Huh, and J.H. Lee, Reduction of NOx, smoke and BSFC with optimal injection timing and emulsion ratio of wateremulsified diesel. Inst. of Mech. Engr., 2001. 215(D): p. 83-93.
[27] Tajima, H., K. TAKASAKI, M. Nakashima, et al. Visual study on combustion of low grade fuel water emulsion. in COMODIA. 2001. Nagoya, Japan.
[28] Wang, C.-H. and J.-T. Chen, An experimental investigation of the burning characteristics of water oil emulsions. Heat Mass Transfer, 1996. 23(6): p. 823-834