Influence of Crystal Orientation on Electromechanical Behaviors of Relaxor Ferroelectric P(VDF-TrFE-CTFE) Terpolymer
Commenced in January 2007
Frequency: Monthly
Edition: International
Paper Count: 32799
Influence of Crystal Orientation on Electromechanical Behaviors of Relaxor Ferroelectric P(VDF-TrFE-CTFE) Terpolymer

Authors: Qing Liu, Jean-Fabien Capsal, Claude Richard

Abstract:

In this current contribution, authors are dedicated to investigate influence of the crystal lamellae orientation on electromechanical behaviors of relaxor ferroelectric Poly (vinylidene fluoride –trifluoroethylene -chlorotrifluoroethylene) (P(VDF-TrFE-CTFE)) films by control of polymer microstructure, aiming to picture the full map of structure-property relationship. In order to define their crystal orientation films, terpolymer films were fabricated by solution-casting, stretching and hot-pressing process. Differential scanning calorimetry, impedance analyzer, and tensile strength techniques were employed to characterize crystallographic parameters, dielectric permittivity, and elastic Young’s modulus respectively. In addition, large electrical induced out-of-plane electrostrictive strain was obtained by cantilever beam mode. Consequently, as-casted pristine films exhibited surprisingly high electrostrictive strain 0.1774% due to considerably small value of elastic Young’s modulus although relatively low dielectric permittivity. Such reasons contributed to large mechanical elastic energy density. Instead, due to 2 folds increase of elastic Young’s modulus and less than 50% augmentation of dielectric constant, fullycrystallized film showed weak electrostrictive behavior and mechanical energy density as well. And subjected to mechanical stretching process, Film C exhibited stronger dielectric constant and out-performed electrostrictive strain over Film B because edge-on crystal lamellae orientation induced by uniaxially mechanical stretch. Hot-press films were compared in term of cooling rate. Rather large electrostrictive strain of 0.2788% for hot-pressed Film D in quenching process was observed although its dielectric permittivity equivalent to that of pristine as-casted Film A, showing highest mechanical elastic energy density value of 359.5 J/m3. In hot-press cooling process, dielectric permittivity of Film E saw values at 48.8 concomitant with ca.100% increase of Young’s modulus. Films with intermediate mechanical energy density were obtained.

Keywords: Crystal orientation, electrostrictive strain, mechanical energy density, permittivity, relaxor ferroelectric.

Digital Object Identifier (DOI): doi.org/10.5281/zenodo.1110892

Procedia APA BibTeX Chicago EndNote Harvard JSON MLA RIS XML ISO 690 PDF Downloads 1622

References:


[1] Park, C., et al., Actuating single wall carbon nanotube-polymer composites: intrinsic unimorphs. Advanced Materials, 2008. 20(11): p. 2074.
[2] Carpi, F., et al., Dielectric elastomers as electromechanical transducers: Fundamentals, materials, devices, models and applications of an emerging electroactive polymer technology. 2011: Elsevier.
[3] Zhao, X.L., et al., Enhanced dielectric and ferroelectric properties in the artificial polymer multilayers. Applied Physics Letters, 2014. 104(8): p. 082903.
[4] Haines, C.S., et al., Artificial muscles from fishing line and sewing thread. science, 2014. 343(6173): p. 868-872.
[5] Huang, M., et al., Nanomechanical architecture of semiconductor nanomembranes. Nanoscale, 2011. 3(1): p. 96-120.
[6] Zhang, Q., V. Bharti, and X. Zhao, Giant electrostriction and relaxor ferroelectric behavior in electron-irradiated poly (vinylidene fluoridetrifluoroethylene) copolymer. Science, 1998. 280(5372): p. 2101-2104.
[7] Chu, B., et al., A dielectric polymer with high electric energy density and fast discharge speed. Science, 2006. 313(5785): p. 334-336.
[8] Buckley, G., et al., Electrostrictive Properties of Poly (vinylidenefluoride-trifluoroethylene-chlorotrifluoroethylene). Chemistry of Materials, 2002. 14(6): p. 2590-2593.
[9] Bao, H.M., et al., Phase transitions and ferroelectric relaxor behavior in P(VDF-TrFE-CFE) terpolymers. Macromolecules, 2007. 40(7): p. 2371- 2379.
[10] Cheng, Z.-Y., et al., Electrostrictive poly (vinylidene fluoridetrifluoroethylene) copolymers. Sensors and Actuators A: Physical, 2001. 90(1): p. 138-147.
[11] Kremer, F., Broadband dielectric spectroscopy. 2003: Springer Science & Business Media.
[12] Garrett, J., et al., Electrostrictive behavior of poly (vinylidene fluoridetrifluoroethylene- chlorotrifluoroethylene). Applied Physics Letters, 2003. 83(6): p. 1190-1192.
[13] Neese, B., et al., Large electrocaloric effect in ferroelectric polymers near room temperature. Science, 2008. 321(5890): p. 821-823.
[14] Smith, O.N.L., et al., Enhanced Permittivity and Energy Density in Neat Poly (vinylidene fluoride-trifluoroethylene-chlorotrifluoroethylene) Terpolymer Films through Control of Morphology. ACS applied materials & interfaces, 2014. 6(12): p. 9584-9589.
[15] Tan, S., et al., Significantly improving dielectric and energy storage properties via uniaxially stretching crosslinked P (VDF-co-TrFE) films. Journal of Materials Chemistry A, 2013. 1(35): p. 10353-10361.
[16] Yang, L., et al., Relaxor Ferroelectric Behavior from Strong Physical Pinning in a Poly(vinylidene fluoride-co-trifluoroethylene-cochlorotrifluoroethylene) Random Terpolymer. Macromolecules, 2014. 47(22): p. 8119-8125.
[17] Gregorio Jr, R. and E. Ueno, Effect of crystalline phase, orientation and temperature on the dielectric properties of poly (vinylidene fluoride)(PVDF). Journal of Materials Science, 1999. 34(18): p. 4489- 4500.
[18] Guan, F., et al., Crystal orientation effect on electric energy storage in poly (vinylidene fluoride-co-hexafluoropropylene) copolymers. Macromolecules, 2009. 43(1): p. 384-392.
[19] Guan, F., et al., Effects of polymorphism and crystallite size on dipole reorientation in poly (vinylidene fluoride) and its random copolymers. Macromolecules, 2010. 43(16): p. 6739-6748.
[20] Wang, J., et al., Transition from relaxor to ferroelectric-like phase in poly (vinylideneflouride-trifluoroethylene-chloroflouroethylene) terpolymer ultrathin films. Applied Physics Letters, 2011. 98(5): p. 052906.
[21] Li, Q., et al., Solution-processed ferroelectric terpolymer nanocomposites with high breakdown strength and energy density utilizing boron nitride nanosheets. Energy & Environmental Science, 2015. 8(3): p. 922-931.
[22] Furukawa, T. and T. Wang, Measurements and properties of ferroelectric polymers. Vol. 5. 1988: Chapman and Hall: New York.
[23] Hahn, B., J. Wendorff, and D.Y. Yoon, Dielectric relaxation of the crystal-amorphous interphase in poly (vinylidene fluoride) and its blends with poly (methyl methacrylate). Macromolecules, 1985. 18(4): p. 718-721.
[24] Xu, H., et al., Ferroelectric and electromechanical properties of poly (vinylidene-fluoride–trifluoroethylene–chlorotrifluoroethylene) terpolymer. Applied Physics Letters, 2001. 78(16): p. 2360-2362.
[25] You, J., et al., Crystal Orientation Behavior and Shape-Memory Performance of Poly (vinylidene fluoride)/Acrylic Copolymer Blends. The Journal of Physical Chemistry B, 2012. 116(4): p. 1256-1264.